This product includes the device only.  An 18650 Battery, 18650 charger, compatible atomizer or cartomizer, and e-liquid is needed for use.

The full starter kit can be purchase here:  Bomber Variable Voltage Mod Starter Kit

The Bomber Features:

• 1- power button
• 1- voltage up button
• 1- voltage down button
• 1- activation button
• 1- LCD screen, which shows the current voltage the device is set on.
• 1- 510 threaded connection
• 1- vented removable end cap w/ spring for battery tension

Specs:

• Selectable voltage from 3v to 6v in 0.1v increments
• Power on/Off Button - hold the button down for 5 seconds to turn the device on, hold the button again for 5 seconds to turn the device off.
• + Button: On press, increases voltage by .1 increments between 3volt and 6 volt. When you reach 6 volts, the device cycles back to 3 volts
• - Button: On press, decreases voltage by .1 increments between 3volt and 6 volt. When you reach 3 volts, the device cycles back to 6 volts
• + and – Button: Press and hold both buttons for five second to disable the + and – button, locking the device on the voltage it is currently set at.
• Regulated output which keeps the voltage the same with each puff - regardless of the remaining battery power. As the battery drains, the device will keep the voltage consistent.
• If the activation button is held down for 10 seconds or longer, the device will shut itself off until the button is released. To prevent overheating the atomizer and the device.
• Short Circuit/Atomizer Protection. The device can recognize an atomizer with too low of a resistance for the current voltage setting and will drop the voltage to 3.7v to protect both the battery and atomizer. If the atomizer is too low or shorted out it will shut off power to the device to protect the device from being damaged.
• Reverse Battery Protection – Protects the device in case you put the battery in the device backwards
• Battery Monitoring/Over-Discharge Protection – The device will monitor the battery voltage and automatically turn off when the battery is discharged, preventing damage to the battery by overly depleting it.
• Amperage Limiting to 2.5 amps – The device should monitor and shut itself off if it detects any excessive over-current conditions.
• Vent hole on the bottom of the device for added safety

**Not Recommended for new e-cig users