How to Use your Vision Victory:

• To fill, turn the tank upside down and remove the threaded end cap (Only the smaller threaded piece will screw off, the larger metal piece attached to the tank cannot be removed).  Fill the outer portion of the tank (avoid getting e-liquid into the center airflow tube).  Screw the head and wick assembly onto the threaded end cap tightly then screw the end cap onto the tank tightly.  You can now turn it rightside up and check for leaks before using.
• Gurgling or Leaking can occur if liquid gets into the center airflow tube.  To clear this liquid and improve performance remove the tank from the battery and blow through the mouthpiece into a paper towel.  The excess liquid will come out of the threaded end of the device.  If this happens often you may need to check that all connections are screwed down tightly or replace the head and wick assembly with a new one.
• The head and wick assembly will sometimes loosen itself when the threaed end cap is unscrewed.  Always check that it is screwed on tightly before replacing the threaded end cap.  Not doing so could result in a leaking or non-working device.
• You should never run the tank completely dry.  Doing so could result in a burnt or damaged wick and can cause leaking.  Refill the tank when the liquid level reaches approximately 1/3 full
• The lifespan of replacement heads can vary quite a bit, but following the above instructions will maximize the lifespan of the coil.